| 释义 |
Definition of brad in English: bradnoun bradbræd A nail of rectangular cross section with a flat tip and a small, typically asymmetrical head. Example sentencesExamples - To attach the two outer frames to one another, I nailed brads through a 1-inch wood block that I had placed between the frames on the inside perimeter.
- Attach plywood with panel adhesive and brads and sand it flush with front edge.
- Attach the flower to the bottom left with a brad.
- Use a handsaw and miter box to cut four pieces of L-shaped edge molding to fit around the canvas; secure the molding by hammering several brads through the back of it and into the wood frame holding the canvas.
- To finish the piece, I positioned the calendar over the face of the first frame and attached it at the top and bottom using 3/8-inch brass brads so the pages could be flipped easily.
- Attach the center dial to the calculator with a brad or thumbtack.
- After the counter is installed on top of the cabinet, the wood strip is attached to the front edge of the counter using glue and small, air-driven brads.
- If you've taught in a classroom, you're probably familiar with the concept, but must still admire the inexpensive and extensive sets that only need scissors, glue, and brads to put together.
- Cut the vellum in half, and attach each piece to the body with brads.
- His son, Daniel Bisbee, Jr., bought a mill on Second Brook where he made tacks and brads in partnership with Henry Soule.
- I used staples at the top and bottom before face nailing two brads through each short rail of the front and back face frames (into the side frames).
- The mitered corners are glued and nailed together with 1-in. brads.
- Galvanized brads are great if using an air or electric hammer.
- Almost all the squares are tacked to the wall at three corners with tiny brads; a fourth nail was evidently inserted and then removed, leaving a telltale hole.
- All joints must be glued and the trim fastened with brads, preferably using pneumatic nailers, which leave very small fastener holes.
- Nails range from the smallest, thinnest brads to large, weighty spikes.
- Trim was attached with carpenter's glue and brads.
- Drive 5/8-in. brads through the plywood into the cleats.
- These were cut to a 3-inch outside measurement and attached from below with glue and brads.
- Also, brads from a nail gun become almost invisible when nailed.
Origin Late Middle English: from Old Norse broddr 'spike'. Definition of brad in US English: bradnounbradbræd A small wire nail with a small, often asymmetrical head. Example sentencesExamples - Trim was attached with carpenter's glue and brads.
- Almost all the squares are tacked to the wall at three corners with tiny brads; a fourth nail was evidently inserted and then removed, leaving a telltale hole.
- To attach the two outer frames to one another, I nailed brads through a 1-inch wood block that I had placed between the frames on the inside perimeter.
- Drive 5/8-in. brads through the plywood into the cleats.
- After the counter is installed on top of the cabinet, the wood strip is attached to the front edge of the counter using glue and small, air-driven brads.
- Use a handsaw and miter box to cut four pieces of L-shaped edge molding to fit around the canvas; secure the molding by hammering several brads through the back of it and into the wood frame holding the canvas.
- All joints must be glued and the trim fastened with brads, preferably using pneumatic nailers, which leave very small fastener holes.
- Attach the flower to the bottom left with a brad.
- Nails range from the smallest, thinnest brads to large, weighty spikes.
- The mitered corners are glued and nailed together with 1-in. brads.
- His son, Daniel Bisbee, Jr., bought a mill on Second Brook where he made tacks and brads in partnership with Henry Soule.
- If you've taught in a classroom, you're probably familiar with the concept, but must still admire the inexpensive and extensive sets that only need scissors, glue, and brads to put together.
- Galvanized brads are great if using an air or electric hammer.
- These were cut to a 3-inch outside measurement and attached from below with glue and brads.
- Attach plywood with panel adhesive and brads and sand it flush with front edge.
- Also, brads from a nail gun become almost invisible when nailed.
- Attach the center dial to the calculator with a brad or thumbtack.
- I used staples at the top and bottom before face nailing two brads through each short rail of the front and back face frames (into the side frames).
- Cut the vellum in half, and attach each piece to the body with brads.
- To finish the piece, I positioned the calendar over the face of the first frame and attached it at the top and bottom using 3/8-inch brass brads so the pages could be flipped easily.
Origin Late Middle English: from Old Norse broddr ‘spike’. |